FLUX H13 HEPA Filter for BeamAir

£133.46 £111.22
In stock
SKU
BEAMAIR-HEPA

For FLUX laser cutter machines click here.

H13 HEPA Filter Replacement

This is the replacement HEPA filter for your Beam Air, it needs to be replaced every 300-600 hours.

Don't forget to replace the other filters in time:

  • Pre-Filter (10-30 hours)
  • Medium efficiency filter (50-150 hours)
  • H13 HEPA filter (100-200 hours)
  • Charcoal filter (300-600 hours)

Remove the filters:

Just open the top cover of the filter and remove the box from the inside. Then take out the Pre-filter and pull on the lids on each side of the Medium efficiency filter, put this aside and repeat the same steps with the charcoal filter. The box that's left is the H13 HEPA filter. Replace what is necessary.


Reassemble:

Reinsert the filters in this order: From left to right

  1. Bottom
  2. H13 HEPA filter
  3. Charcoal filter
  4. Medium efficiency filter
  5. Pre-filter
  6. Lid

Once you have placed your filters in that order, finish by placing the top of the Beam Air back on top and you are ready to start creating even more fabulous creations!


What's in the Box

  • 1 x H13 HEPA Filter
Write Your Own Review
You're reviewing:FLUX H13 HEPA Filter for BeamAir